• What accessories come in the box?
    • multi region micro USB charger
    • manuals on USB flash drive
  • What are the pins used for in the :pulse and :wave?

     

    Lemo 2:

    Pin 1 – Ground

    Pin 2 – Power In (9-36V)

     

    Lemo 5:

    Pin 1 – Ground

    Pin 2 – LTC In/Out (it depends of the mode, it can be both: input or output)

    Pin 3 – Not in use

    Pin 4 – Power In (9-36V)

    Pin 5 – LTC Out

     

    Lemo 9:

    Pin 1 – Ground

    Pin 2 – LTC In/Out (it depends of the mode, it can be both: input or output)

    Pin 3 – Not in use

    Pin 5 – RX+ RS422

    Pin 6 – RX- RS422

    Pin 7 – TX+ RS422

    Pin 8 – TX- RS422

    Pin 9 – Not in use

  • Can I charge my :pulse via ethernet?
    1. When the pulse is connect via a suitable ethernet cable to the Arri Alexa camera then it can receive power via the ethernet cable. (PoE)
    2. When connected to a network you will only be able to charge via PoE if you have an older style of hub that powers a device all the time, not the modern intelligent type of router/switch that detects the power requirements of the connected devices.

     

  • Can I assign a static IP address to my :pulse?

    There is no facility for adding a static IP address to a pulse. The pulse derives it's ethernet IP address from a DHCP server on the network it is connected to or generates it's own in Soft AP mode.