Set the Timecode for the Master - SyncBac PRO

Note: This section only applies if you have set your SyncBac PRO to run in GP Master TX mode (see Set the Timecode Mode).

You need to set the timecode for the master SyncBac PRO, so that it has the time settings you require. These time settings will then be sent to the slave SyncBac PROs that are in the same RF network as the master SyncBac PRO.

To set your SyncBac PRO's timecode:

  1. Connect your SyncBac PRO to your GoPro HERO. For details, see Connect SyncBac PRO to a GoPro HERO4 or Connect SyncBac PRO to a GoPro HERO6.
  1. Switch on your SyncBac PRO (see Switch SyncBac PRO On and Off).

  2. Press the Select button.

  3. Use the Up and Down buttons to scroll to the Set TimeCode option. This option is only available if the SyncBac PRO is in GP Master TX mode (see Set the Timecode Mode).
  4. Press the Select button.

  5. Use the Up, Down, and Select buttons to set the SyncBac PRO's time. Press Up or Down to change the value of a character, and then press Select to confirm that value and move to the next character (from left to right). When you have set the last value, pressing Select will confirm the time entry.

 

If you are setting up a SyncBac PRO to run as a master, you also need to Set the Frame Rate Per Second for the Master.

Powered by Zendesk