Set the Time Code for the Master - SyncBac PRO

Note: This section only applies if you have set your SyncBac PRO to run in GP Master TX mode (see SyncBac PRO has two different Timecode modes: RF Slave and GP Master TX. These modes define how your SyncBac PRO's clock is synchronised with other devices, and so it is important that you choose the appropriate setting.).

You need to set the timecode for the master SyncBac PRO, so that it has the clock settings you require. These clock settings will then be sent to the slave SyncBac PROs that are in the same BLINK network as the master SyncBac PRO.

To set your SyncBac PRO's timecode:

  1. Connect your SyncBac PRO to a HERO4™ (if it is not connected already). For further details, see Connect SyncBac PRO to a GoPro HERO4™.

  2. If your SyncBac PRO is currently off, switch it on (see To switch your SyncBac PRO on:).

  3. Press the Select button.

  4. Use the Up and Down buttons to scroll to the Set TimeCode option. This option is only available if the SyncBac PRO is in GP Master TX mode (see SyncBac PRO has two different Timecode modes: RF Slave and GP Master TX. These modes define how your SyncBac PRO's clock is synchronised with other devices, and so it is important that you choose the appropriate setting.).
  5. Press the Select button.

  6. Use the Up, Down, and Select buttons to set the SyncBac PRO's time. Press Up or Down to change the value of a character, and then press Select to confirm that value and move to the next character (from left to right). When you have set the last value, pressing Select will confirm the time entry.

 

If you are setting up a SyncBac PRO to run as a master, you also need to This section only applies if you have set your SyncBac PRO to run in GP Master TX mode (see SyncBac PRO has two different Timecode modes: RF Slave and GP Master TX. These modes define how your SyncBac PRO's clock is synchronised with other devices, and so it is important that you choose the appropriate setting.)..

Powered by Zendesk