Set the Timecode for the Master
Note: This section only applies if you have set your UltraSync ONE to run in Master TX mode (see Master TX UltraSync ONE - Set Up).
If your UltraSync ONE is set to run in Master TX mode, it means it is the master in an RF network. As it is the master, you need to set its timecode. The timecode will then be transmitted to the slaves in the network, so that they can synchronise with the master.
To set your UltraSync ONE's timecode:
-
Make sure your UltraSync ONE is switched on (see Switch UltraSync ONE On and Off).
-
Press the Select button.
- Use the Up and Down buttons to scroll to the TC Generator option.
-
Press the Select button.
-
Use the Up, Down, and Select buttons to set the UltraSync ONE's time. Press Up or Down to change the value of a character, and then press Select to confirm that value and move to the next character (from left to right). When you have set the last value, pressing Select will confirm the time entry.
You also need to Set the Frame Rate Per Second.
