Change the Screen Saver Time

By default, the UltraSync ONE's screen is lit at the set brightness level all of the time. This makes it easier to read the display, but uses up more battery power. If you want to reduce the use of battery power, or just prefer the screen to dim after a short amount of time, you should change the Display Settings.

1. Make sure your UltraSync ONE is switched on (see Switch UltraSync ONE On and Off).

2. Press the Select button.

3. Use the Up and Down buttons to scroll to Display Settings.

4. Press the Select button.

5. Use the Up and Down buttons to scroll to your preferred screen light display time:
   • Always on to have the screen lit all of the time.
   • Short timed on to have the screen lit for approximately 10 seconds after the last button press.
   • Long timed on to have the screen lit for approximately 20 seconds after the last press of the Up, Down, or Select button. The screen will dim as long as you don't press any of the buttons.

   Note: As soon as you press the Up, Down, or Select button, the dim timer is reset.

6. Press the Select button to confirm.