Set the Frame Rate Per Second

Note: This section only applies if your UltraSync ONE is running in Master TX mode or is free running in Free Run/Jam-Ext mode. If your UltraSync ONE is running in Ext LTC Int or RF Slave mode, it will receive the FPS data from the master or external timecode source.

The FPS (Frames-Per-Second) of your UltraSync ONE has to match the FPS of the cameras and sound mixers/recorders that are being used on the shoot. This is because timecode can only be applied accurately to each recorded frame if the same FPS settings are used.

To set the FPS:

1. Make sure your UltraSync ONE is switched on (see Switch UltraSync ONE On and Off).

2. Press the Select button.

3. Use the Up and Down buttons to scroll to the TC Generator option.

4. Press the Select button.

5. Use the Up and Down buttons to scroll to the Set FPS Rate option.

6. Press the Select button.

7. Use the Up and Down buttons to set the UltraSync ONE's FPS to the appropriate value.

8. Press the Select button to confirm.

You also need to Set the Timecode for the Master.

Note: If your UltraSync ONE is running in Master TX mode, it will send the FPS to the slave units in the RF network, so that they also use the same FPS.